ASV RC-30 Troubleshooting Techniques

Problem: Machine starts but hydraulics will not operate.

Probable cause:
1. Lap bar must be in down position, operator must be seated in seat, and front door (if installed) must be closed .
2.Safety fuse blown
3. Faulty operator presence switch.
    a) Test continuity through seat, lap bar, and door switch. Adjust or replace as necessary. Lap bar and door switch are magnetic switches and should be adjustedto apporximately 1/16 inch away from steel pickup bracket.
4. poor ground (check ground wires on bottom left near rear side of hydraulic reservoir).
5. Safety relay is not activating
6. Faulty safety solenoid or safety solenoid spool.
7. Poor wire connections on fuse, relay, or sfaety solenoid.
8. Low charge pressure.

Back To Top